Photography Magazine

If you have been following our tutorials on panoramic photography, you were probably able to make near perfect panoramic images, with a little bit of luck. If your photographs didn’t seem to stitch together well, the most probable cause is that you had objects very close to you. Read on…

If you have been shooting panoramas hand-held, its about time you started using a tripod. And not just any tripod (although just any tripod is better than no tripod at all). Let us consider an ordinary tripod with a regular camera mounted on it. Try this test - compose your viewfinder image in such a manner so as to have a vertical line close to the camera (say 2 or 3 feet away) and another away from the camera (maybe 6 to 10 feet away). The closer vertical line could simply mean the edge of a near object such as a computer monitor or a fence (if outdoors). Similarly the further vertical line could be the edge of an object or a wall some distance away from your camera. Notice the distance between the two vertical lines in your view finder. Now, turn the tripod head towards the right or to the left while keeping your eyes on the distance between the two (vertical lines). Nine times out of ten, the gap will seemingly increase or decrease as you rotate the tripod head. This is simply thanks to the parallax error caused by the fact the camera does not have its tripod mount socket located at the optic center of the lens. In fact it is not possible to have the tripod mount at the optic center of the lens, since that point is somewhere inside the camera body! To avoid the parallax error, we need to make sure that the camera is mounted to the tripod in such a manner so as to rotate from its optic center when you turn the tripod head. That is the only way you can shoot perfect panoramas.

That is exactly where the panoramic tripod head can help, and it is specifically designed so as to allow you to shoot perfect panoramic images that can be stitched to each other without a problem. The panoramic head usually has a vertical arm and a horizontal arm that allow you to move the camera mount horizontally as well as vertically. To adjust the camera so as to allow it to rotate from the optic center of the lens, you need to mount the camera on the tripod indirectly using the panoramic head (the panoramic head fits on to your regular tripod head). Then you need to, as mentioned earlier, position your camera so you see one near and one far vertical line in the finder. Now, you experiment by moving the camera vertically and/or horizontally until it is positioned in such a manner so as to totally avoid the parallax error. By this we mean, there would be no change in the distance between the two vertical lines when you rotate the camera this way or that.